鍛造鍍鉻 主缸

Flat terminal type
1/2 inch (approx. 12.7mm) for front
Applicable handlebar outer diameter: φ22.2
Mirror Hole Diameter: M10 x P1.25 right hand thread
Banjo Bolt Size: M10 x P1.25

*■Warning
*Since these are important safety parts, please have them removed and installed at a certified factory or other store with appropriate facilities, skills, and knowledgeable mechanics.If the work is not performed properly, there is a risk of serious accidents resulting in death.We are not responsible for any problems or accidents that occur without defects in the product itself.
*Please check your bike's stock brake system carefully (not for ABS bikes) and select the appropriate piston diameter in advance.If the piston diameter is not appropriate, the required braking force cannot be secured, which may lead to a serious accident resulting in death.
*Designed for brake use only. Cannot be used as a hydraulic clutch.
*Not for ABS bikes.The brake switch may not operate properly, for example, if it is operated in reverse.
*Since the lever position cannot be adjusted, this product is not compatible with bikes such as 1B7B- MAXAM that use the stock lever adjuster.
*Handle outer diameter Φ22.2 only.Not available for bikes with stock size bar such as Skywave SS.
*After installing the product, please be sure to run through the break-in period to fully check the difference in lever touch and braking force.Failure to do so may result in serious accidents, even fatal ones.
*Please refer to the compatibility chart in our catalog (latest version) for installation guidelines for major big scooters.Models not listed have not been tested for installation on actual bikes.For some HONDA big scooters, we recommend a different piston diameter from the stock one, but this should be considered as a rough guide.Due to structural differences, even if the product has the same piston diameter as the stock, the brake feel will not be exactly the same as before, so please understand that the feel may be different from your preference.
*The left side of the flat terminal type has a three-pole terminal that is compatible with the two-stage switch on the rear side of HONDA big scooters (except for MF11 FAZE and other noncompliant models).Please be sure to insulate the terminals that are not required for YAMAHA & SUZUKI big scooters.
*Combination with brake systems other than the stock brake system, such as large-diameter disc rotors and calipers, has not been tested (not covered by the warranty).
*When replacing the master cylinder, it is necessary to replace the gaskets and bleed the brake air.Be especially careful when bleeding air from bikes with front and rear combination brakes.In addition, please use brake fluid specified by the bike manufacturer (DOT5 is not acceptable).The direction and angle of the brake hose is different from the stock one.Be sure to select a brake hose with the appropriate fitting shape and length for your bike.
*No lever position adjustment function.The position of the lever may differ from your preferred one.
*Since the lever position cannot be adjusted, this product is not compatible with bikes such as 1B7B- MAXAM that use the stock lever adjuster.
*Mirror adapter, banjo bolts and gaskets are sold separately.
*Use of brake fluid, grease, sebum, water, salt, dirt. adhering to the surface for a long time may cause unexpected damage to the painted surface, peeling of the plating, rust. (None of the above is covered by warranty).Please keep in mind that the quality of the products manufactured non Japanese is not equivalent to the quality of products manufactured in Japan, and daily maintenance is required..

Click here for the instruction manual
Repair parts are here..